Help please
Hey guys. I removed the rubber donut that sits between the idle adjustment double nut. And It fell sowhere in the engine.
I'm afraid it's lost for good. Does anyone know where i can get another one?
Greg A
IAP should have them, I don't see them on the website, but give them a call.
http://www.international-auto.com/
http://www.international-auto.com/
- Alfa GTV6 NZ
- Gold
- Posts: 87
- Joined: Tue Dec 07, 2004 2:39 am
- Location: Christchurch, New Zealand
Is it the one between the plenum and the double nut adjuster?
If so then any correct sized rubber o-ring should do the trick.
The trick with this is when you tighten the adjuster it squashes the o-ring and makes the hole smaller, and so lets less air pass. I'm guessing you all knew that.
I replace mine every once and a while as they can get out of shape or loose their squishyness.
If so then any correct sized rubber o-ring should do the trick.
The trick with this is when you tighten the adjuster it squashes the o-ring and makes the hole smaller, and so lets less air pass. I'm guessing you all knew that.
I replace mine every once and a while as they can get out of shape or loose their squishyness.
1987 GTV6 - Livin in New Zealand.
Re: rubber donut for idle
Hi all,
does anyone have the thickness and the exact size of this donut? Mine has already shrinked and it is difficult to see the right size. I already tried a few ones, but none of them worked well, idle was always difficult to set.
Or does one know where to get them? (other than international-auto)
Thx
pat
does anyone have the thickness and the exact size of this donut? Mine has already shrinked and it is difficult to see the right size. I already tried a few ones, but none of them worked well, idle was always difficult to set.
Or does one know where to get them? (other than international-auto)
Thx
pat
Re: rubber donut for idle
Hey pat,
luck for you i made a note of the size before i installed.
I purchased it from I.A.P.
I.D. 5.84mm
O.D 12.70mm
Thickness 3.42mm
Greg
luck for you i made a note of the size before i installed.
I purchased it from I.A.P.
I.D. 5.84mm
O.D 12.70mm
Thickness 3.42mm
Greg
Re: rubber donut for idle
Thanks Greg! For anyone else searching them: at IAP they are item #16991.
Regards, pat
Regards, pat
-
- Silver
- Posts: 2
- Joined: Fri Aug 20, 2010 8:31 pm
Re: rubber donut for idle
hello
this is Dexter
and i want to know something good about this topic
and it would be good reply ok
_______________
"Want to get-on Google's first page and loads of traffic to your website? Hire a SEO Specialist from Ocean Groups seo pecialist
"
this is Dexter
and i want to know something good about this topic
and it would be good reply ok
_______________
"Want to get-on Google's first page and loads of traffic to your website? Hire a SEO Specialist from Ocean Groups seo pecialist
"