![Image](http://www.jakita.com/pics/Qm2.jpg)
![Image](http://www.jakita.com/pics/Levyt2.jpg)
The plan is to use one disk at the time. Another on the pic is just a spare. The pressure plate weights less than 1.9 kilos and the disk with center weights 0.6 kg.
And as always, there must be also a question.
Can you suggest any throw out bearing to use? Should be a one with radius contact patch to match pressure plate.
Also would like to found actuator which could been mountend around the clutch axle with some more piston area than the original. I remember that that kind of actuators are used in some Saab's (95?), but don't know about the dimensions.