today i striped down 3 gearboxes 1 alfetta gtv 2.0 karb(41/10) 1alfa 75 2,0 karb(43/10 ?!?) and 1 from 75TS(41/10LSD) good news are that pignion shaft are identical so if clutch shafts are same its posible to make close ratio set ... i want to transfer only 1 gear from TS to alfetta , so ratio spacing will become ever close between famous 1-2 shifts and less abuse for synchro but diameter of 1 gear on clutch shafts is so small .. i doubt is it posiible to cut then spline-press on maschined alfetta shaftMats wrote:Not sure about this but the diameters of the shafts between the Alfetta and 75 boxes are not the same, neither is the splines for the fifth/reverse gear assembly.
some update ... bad news Mats is right clutch shaft reverse-fifth gear have completely differnet splines ... may be 3-4 is different too
here some pics .. note spacer between 4-5 gear that wears out and cause diff whine with 90-100 km/h on 4-5 gear ... original tickness is 2mm .. on my TS box was 0.5mm this clearence cause pignon shaft to float for-backward
here some pics .. note spacer between 4-5 gear that wears out and cause diff whine with 90-100 km/h on 4-5 gear ... original tickness is 2mm .. on my TS box was 0.5mm this clearence cause pignon shaft to float for-backward
- Attachments
-
- HPIM0883.JPG (211.08 KiB) Viewed 2916 times
-
- HPIM0886.JPG (215.38 KiB) Viewed 2917 times
-
- HPIM0887.JPG (204.68 KiB) Viewed 2917 times
-
- HPIM0888.JPG (196.15 KiB) Viewed 2916 times
-
- HPIM0890.JPG (201.85 KiB) Viewed 2917 times