Hello,
I was hoping to have my drive shaft back but I ran into two issues.
1). I lost the pinch bolt to attached the front drive shaft to the three prong part that holds the front Guibo. Does anyone know the dimensions and size of this bolt so I can locate another one? I need this before I can complete the balance of my drive shaft.
2). The rear pilot bearing is too large for my new rear guibo. It fits in perfect with my old guibo which makes me belive that my new rear guibo is a defect. Anyone run into this or have any thoughts on this?
Thanks for any suggestions.
Re: Drive Shaft Pinch Bolt & Pilot Bearning too Large
hope i understand as fine...cchan wrote:Hello,
1). I lost the pinch bolt to attached the front drive shaft to the three prong part that holds the front Guibo. Does anyone know the dimensions and size of this bolt so I can locate another one? I need this before I can complete the balance of my drive shaft.
the screw that pinch the steel part that hold the flutes of the shaft.
hex head metric m10 fine tread 1.25 length 40 to 45
non treaded length no more than 23-24mm.
2 stroke addict