Does someone know the diameter of the big (liner) end of the cylinder liner tool?
I'm going to make up a few for my 3.0. I can figure out how long to make it and the hole size, but I dont have a good way to figure out the diameter.
Thanks,
zig
Cylinder liner holder tool
MR1 Zig (I made rate!)
Machinery Repairman USNR
Machinery Repairman USNR
Re: Cylinder liner holder tool
If they are the same as the Nord ones I can measure mine next time I'm in the garage.MR2 Zig wrote:Does someone know the diameter of the big (liner) end of the cylinder liner tool?
I'm going to make up a few for my 3.0. I can figure out how long to make it and the hole size, but I dont have a good way to figure out the diameter.
Thanks,
zig
Mats Strandberg
-Scuderia Rosso- Now burned to the ground...
-onemanracing.com-
-Strandberg.photography-
GTV 2000 -77 - Died in the fire.
155 V6 Sport -96 - Sold!
-Scuderia Rosso- Now burned to the ground...
-onemanracing.com-
-Strandberg.photography-
GTV 2000 -77 - Died in the fire.
155 V6 Sport -96 - Sold!
Re: Cylinder liner holder tool
Mats,
I think they are the same (think).
Thanks,
zig
I think they are the same (think).
Thanks,
zig
MR1 Zig (I made rate!)
Machinery Repairman USNR
Machinery Repairman USNR