ALFAGTV6.COM

[hexen]

My first trackday track : 1.8 carb 124HP with 1.6 gearbox, alfa 6 drivetrain and brake



My new car with v6 24v

engine from 164 v6 with motronic and big pipe from 166
read and front hub from alfa 6 (5x112)
Front brake mercede classe S of 330mm with peugeot 607 caliper
Rear brake mercedes classe s rotor with alfa 75 front caliper
TS gearbox with 2nd and 3th gear lightned, 45% lsd and direct linkage
Coilover in the front
suspension with unibal



http://hexenberg.free.fr/75/version_2.htm

[kevin]

Wow , lots of mods you have done . Would be interesting so see pics of your front and rear brake set ups . Have you used the standard Alfa front hubs on the front ?

[hexen]

Not the 75 standard front hub, but the alfa 6 front hub

[hexen]

[kevin]

Wow , I went through your thread on your build . You have done a lot of work . I used to have the Alfa 6 uprights but did not use them as was worried the steering arms were pulled to far back as the arms off the hub are much longer .

[hexen]

Yes the alfa 6 hub are longer than 75 hub, but with this extra longer the lower arm is a litle bit down than the 75.

IT's look not to bad in vidéo

http://www.dailymotion.com/video/x11o0k ... -pneu_auto

In the befing of the year I have also rebuild the engine (I broke it at Monthlery) and ad a scrapper and remove 0.8 in the cylinder head.

[kevin]

Video gives a good perspective of the tyre contact patch through the corners . What is the rate in the front springs . Do you have it in kg/ cm .

[hexen]

I don't know the rate of the spring

[hexen]

few video, outiside my ca

http://www.dailymotion.com/video/x213sv ... -2014_auto

inside my car

http://www.dailymotion.com/video/x213m7 ... 14h30_auto

http://www.dailymotion.com/video/x215cc ... 4-11h_auto