-
- Gold
- Posts: 166
- Joined: Wed Dec 29, 2004 5:55 pm
- Location: Marysville, WA. USA
Removing Door Stripes
Anyone out there have suggestions on removing pin stripes ?
They look like factory tape type stripes on the door I installed and I'd like to remove them without damaging the paint.
Thanks,
Merril
They look like factory tape type stripes on the door I installed and I'd like to remove them without damaging the paint.
Thanks,
Merril
82 GTV6 3.0
fingernail at the edge and pull slowly...if they are tape type they should peal right off simply enuf...if not use a SHARP razor blade and work carefully and you wont hurt the paint...get in a hurry and you may scratch it a bit but nothing that wont buff out
if any residue is left behind use some goofoff
if any residue is left behind use some goofoff
-
- Gold
- Posts: 166
- Joined: Wed Dec 29, 2004 5:55 pm
- Location: Marysville, WA. USA
-
- Gold
- Posts: 166
- Joined: Wed Dec 29, 2004 5:55 pm
- Location: Marysville, WA. USA
Never heard of that 3M rubber wheel there Mats.
I think I'll try the hair dryer first. Also, the forcast is for 70deg F this Saturday so I'll allow for some heat soak in the sun and give it a try.
That rubber wheel sounds interesting though. If my first try doesn't work out too well, I'll see if I can find that 3M gadget.
Thanks guys,
Merril
I think I'll try the hair dryer first. Also, the forcast is for 70deg F this Saturday so I'll allow for some heat soak in the sun and give it a try.
That rubber wheel sounds interesting though. If my first try doesn't work out too well, I'll see if I can find that 3M gadget.
Thanks guys,
Merril
82 GTV6 3.0
-
- Gold
- Posts: 166
- Joined: Wed Dec 29, 2004 5:55 pm
- Location: Marysville, WA. USA